|
|
Hum on Transmit - FT-1000MP Field
Problem: I picked up my new
FT-1000MP field yesterday and had a few hours on air last night.
(The receiver is quite impressive.) I found that I seem to have
hum (like an earth loop problem) on the audio when I listen on
the monitor. Have other people had similar results??
Solution: I had that problem
when I connected an earth ground to the ground post.
Disconnected it and the hum went away with no other ill effects.
Roger W6VZV
Problem: I have a new 1000
mp Mark V, and Yaesu MD 100 microphone. When radio fan comes on
a loud electric buzz appears in the monitor circuit AND into the
transmitted audio!! Its happened with 3 NEW MD-100 mics! Some MD
100 mics work fine, while others exhibit this ground problem.
Solutions: It happened to me
yesterday - a guy told me I had a hum on my signal turned out it
was because I had my sound card plugged into the patch socket on
the rear don't know if that's pertinent to you, but I could hear
the hum/buzz on the monitor. Tom gm4fdm
This happened to me a few times...seems if you have the monitor
volume level set bit high it happens...It scared the hell out of
me the first time. Ron
I had the same problem and solved it by connecting a ground from
one of the screws that holds the cover on the computer case to
the radio ground. Mark
|
